+ Reply to Thread
Results 1 to 2 of 2

Thread: ptr 4300s problem

  1. #1
    Donor reena is on a distinguished road
    Join Date
    Aug 2011
    Posts
    5
    Thanks
    1
    Thanked 3 Times in 1 Post

    ptr 4300s problem

    When a plate is loaded on the ptr 4300 the transfer path would go halfway down stop and push the plate into the side alignment bar below the register punch. When the sensors start centering the plate the transfer path would very slowly continue going down, forcing the plate out of the punch bar by bending the side of the plate before the punching process takes place.
    What adjustments can I make to stop the transfer path from moving down until the punching process is complete & the plate is drawn back into the transfer path.
    By opening the home side door & when the transfer path makes a stop we put an upward resistance by hand to the side of the transfer path for 2 seconds the machine will work perfectly.

  2. #2
    Junior Member Md.Mazedul Alam is on a distinguished road
    Join Date
    Oct 2011
    Location
    Dhaka,Bangladesh.
    Posts
    10
    Thanks
    3
    Thanked 1 Time in 1 Post
    Quote Originally Posted by reena View Post
    When a plate is loaded on the ptr 4300 the transfer path would go halfway down stop and push the plate into the side alignment bar below the register punch. When the sensors start centering the plate the transfer path would very slowly continue going down, forcing the plate out of the punch bar by bending the side of the plate before the punching process takes place.
    What adjustments can I make to stop the transfer path from moving down until the punching process is complete & the plate is drawn back into the transfer path.
    By opening the home side door & when the transfer path makes a stop we put an upward resistance by hand to the side of the transfer path for 2 seconds the machine will work perfectly.
    Hai Every one. Renna are you solve your problem or it is still now?Because this post
    is posted by 22 th February 2014.If not then I would try. Thanks

+ Reply to Thread

Similar Threads

  1. Replies: 21
    Last Post: 05-22-2017, 04:17 PM
  2. Spooler for SCREEN 4300S
    By elchib in forum PDF & Workflow
    Replies: 10
    Last Post: 02-16-2016, 07:27 PM
  3. We all know this problem
    By ILOVEFONTS in forum Graphic Design
    Replies: 25
    Last Post: 07-03-2015, 12:23 AM
  4. Problem with gum
    By alliswell in forum Computer To Plate
    Replies: 11
    Last Post: 05-20-2012, 11:04 AM
  5. Spooler for SCREEN 4300S
    By elchib in forum Requests
    Replies: 2
    Last Post: 11-25-2011, 06:47 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts