+ Reply to Thread
Results 1 to 3 of 3

Thread: !!! Fuji luxel v-6 laser problem !!!

  1. #1
    Junior Member reprostudio is on a distinguished road
    Join Date
    May 2011
    Location
    Belgrade, SERBIA
    Posts
    13
    Thanks
    7
    Thanked 2 Times in 1 Post

    !!! Fuji luxel v-6 laser problem !!!

    We have a problem with the laser on the machine. When we upload a plate and it takes it in, the laser does not want to go to the start position for the second plate. We have to reset the machine and after the reset it takes the plate in, sometimes we have to reset a couple of times and then it works normally. Does anybody know what could be the problem?

    Thanks in advance

    REPROSTUDIO

  2. #2
    PRC Member ChristianSTG will become famous soon enough
    Join Date
    Dec 2010
    Posts
    186
    Thanks
    8
    Thanked 49 Times in 40 Posts

    Clean encoder first

    Quote Originally Posted by reprostudio View Post
    We have a problem with the laser on the machine. When we upload a plate and it takes it in, the laser does not want to go to the start position for the second plate. We have to reset the machine and after the reset it takes the plate in, sometimes we have to reset a couple of times and then it works normally. Does anybody know what could be the problem?

    Thanks in advance

    REPROSTUDIO
    clean the gold ruler encoder first, and probe, if not check the state of sensor of encoder carrier, whit the servive key pluged and rigth cover open watch if carrier encoder sensor are all time green, orange or red, if all time is green is OK, if red all is bad need mecanical ajustment, and if orange need recalibrate aligment.

  3. The Following User Says Thank You to ChristianSTG For This Useful Post:

  4. #3
    Junior Member reprostudio is on a distinguished road
    Join Date
    May 2011
    Location
    Belgrade, SERBIA
    Posts
    13
    Thanks
    7
    Thanked 2 Times in 1 Post
    @ ChristianSTG, we thank you for your help. We cleaned the gold ruler and for now we don't have any problems the machine is working fine. Thanks once more.

+ Reply to Thread

Similar Threads

  1. Fuji Luxel F-6000
    By Torg20 in forum Computer To Plate
    Replies: 10
    Last Post: 10-19-2013, 01:22 PM
  2. Interface card for fuji luxel v-9600
    By loimagen in forum Computer To Plate
    Replies: 12
    Last Post: 06-04-2013, 07:39 PM
  3. Fuji luxel v6 ctp
    By reprostudio in forum Computer To Plate
    Replies: 6
    Last Post: 04-14-2013, 03:40 PM
  4. Fuji Luxel XMF problem
    By MonteCarlo in forum Imposition & RiP
    Replies: 11
    Last Post: 02-18-2013, 02:10 AM
  5. fuji luxel VX 9600
    By qure in forum Computer To Plate
    Replies: 20
    Last Post: 03-13-2012, 07:35 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts