I n s t a l l i n g P e r m i t F i l e s
If you installed one or more of the modules
listed at the left, install their permit files as
follows.
Step 1 Launch the License Manager program as shown below.
Step 2 Wait for the Licence Manager window to completely open, as shown
below. (This may take awhile.)
Step 3 In the Servers panel, select the WorkMates host computer, and then
click the Add Permit... button shown below.
Step 4 Navigate to the Licenses & Passwords folder you created earlier (page
13).
• RIPMate
• PDFMate
• CheckMate
INSTALLING PERMIT FILES
AG12333 Rev. 27 ECRM WorkMates for Windows Getting Started 37
Step 5 In the “Please select a permit file” window, click on the RIPMate
ECRM____.hqn.permit entry, and then click on the Select button.
In the License Manager window’s, the Licenses panel will
immediately be updated to show the RIPMate permit file has been
installed (see below).
Step 6 If you installed PDFMate and CheckMate, their permit files may have
been bundled in the RIPMate permit file. If so, they will be now be
listed, too. Otherwise, repeat steps 4 and 5 for PDFMate and
CheckMate ECRM____.hqn.permit files.
Step 7 Click on the X box in the upper right corner of the window to close the
Licence Manager utility.
RIPMate
permit file
38 ECRM WorkMates for Windows Getting Started AG12333 Rev. 27
I n s ta l l i n g t h e WorkMates S o ftware
Entering Licenses
Most WorkMates products include at least one licensed module.
Here’s how install your license(s).
Step 1 On the WorkMates workstation, click Start>Programs>ECRM
WorkMates>Tools & Utilities>ECRM License Setup.
•The ECRM License Setup window in the next figure appears. Some
fields may already be filled in.
Step 2 Keeping the window open, navigate to the Licenses & Passwords
folder you created earlier (page 13), and then copy and paste license
numbers from there into the appropriate fields in the ECRM License
Setup window.
If entering an ImposeMate
license, be sure to select its
“level” in the pull-down list
before entering the license.
You must do this to enable
the license.
INITIALIZING THE RIP
AG12333 Rev. 27 ECRM WorkMates for Windows Getting Started 39
Step 3 After you fill in all the fields, click OK. This enters the licenses and
closes the ECRM License Setup window.
The next time the WorkMates server is started, it will recognize the
new licenses and you’ll be able to use the products.
I n i t i a l i z i n g the RIP
Start up the RIP and initialize its settings as explained below
Note: You will not be able to start the WorkMates Server later unless you run
the RIPMate RIP once first as described below.
Step 1 On the WorkMates workstation, launch RIPMate as shown below.
Step 2 If the following dialog appears, click Unlock.
Note: For Vista, run as administrator and add the program to the firewall.
40 ECRM WorkMates for Windows Getting Started AG12333 Rev. 27