I recently managed to obtain wasatch 6.6 + the medicine it requiers to run properly. If you haven't been around a lot lately - I guess I could share.
I have a problem though - my printer is not listed in the devices available. Googling got me to the point where I must contact my printer dealer for a driver, but as it turns out - there is a SPECIAL Wasatch edition for my printer. Since my printer is JETi 3312 it appears I can't use my current wasatch installation.
So... basicly my question is: .. or could I ? Is it possible to add additional printers to the RIP? Any JETi 33xx should do just fine. It's either: 3312, or:
Any JETi FlatBed printer.
A driver for either of the above should do the trick for me. If some has it - please do share.