With regards to Cannot Start Print on Onyx 10, this is what you have to do by :
1. Install Onyx as per instructions
2. replace the files as instructed
3. run p.exe
4. Install the Download Manager
5. Replace the .jar file to stop it asking for the key.
6. Then install the printer.
Now here is the fun part. (and how easy that was)
Go to Onyx website and register (you dont need to provide any Key, registration takes a minute).
After you are registered you can go to Download section.
Download all 3 updates (including HASP)
Now replace all the files again (as per points 2. and 5.)
Run p.exe again
It should send the file to print no problem
Everlastpl, Thank you very much for your reply.
I haven't the printer here, but printing to a file it's OK.
Hi, I had the software working great, but gives me error cannot start print.
I've tried all options for IP configuring, the printer and ONYX are talking to each other, just has that print error.
Any advice on what I may be missing?
Thanks very much,
Good day Sirs!
Your help is needed.
I installed and cracked ONYX 10 following the steps above.
I downloaded .PrnInst for Roland LEJ - 640 and installed the printer.
But when I run Onyx, the console displays a message:
(Error) Faild that load RolandUV.dll .......
Where should I look for the problem? Perhaps the reason in the fact that .PrnInst from another program's version?
I would be grateful for any help in this problem.
Hasp can be downloaded without registering at:
ftp://ftp.onyxgfx.com/ TechSupport / HASP_Drivers /
Printer medias extension prninst:
i too need onyx 10 with crack
Delighted i have this running on my iMac 24 " Early 2008 under Parallels Desktop with win xp.
I am not in any way tech savvy but i managed it, so any struggling just follow the instruction, IT DOES WORK, Kudos to all who were involved in this and the posters also.
PS i didnt download it off this site but i did do what of the posters said, i googled the torrent and downloaded it, all the files you need are in it.
Does any know how to get USB showing in the printer setup part of this software.
Everything works on this version for me with the exception of JAWS RIP GUI crashes everytime I try to RIP a PDF. Any else have this problem and/or a solution?
Any help would be much appreciated. Thanks guys!
I think I managed to install successfully but I found that the printed paper has a white stripe crossed the sheet. What's the remedy? Pity!