I would like to know if you could help me please, when i send a job to the galileo from a apogee print drive series 3, update f, the engine works fine, i mean, place the plate in position, and the spinner starts, but it does not imaging at all, the job in the apogee print drive doesn´t finish, it stay on 94 %, and the galileo engine, never start imaging, and i have to cancel the job to remove the plate, do you know whats going on?,

I´m using an openconnect printdrive apogee series 3, update f, and i use harlequin ripmate 9

i really appreciate all help you could give me

thanks a lot

Best regards!!!!